O.S. Engine OS24604000 Cylinder Head for 46AX RC Engine Replacement  [OS24604000]

O.S. ENGINES CYLINDER HEAD 46AX
Price:
CAD$15.44
Brand:
O.S. Engine
Model:
OS24604000
GTIN:
4531028136199
Condition:
Brand New
Write a review

Replacement Cylinder Head for 46AX Engines

This O.S. Engine OS24604000 cylinder head is specified as a service replacement for the 46AX family. It is intended as a direct service item to restore or maintain the engine top-end, not as a performance upgrade claim.

Installation overview: remove the existing head following the engine manufacturer's service sequence, inspect mating surfaces and gasket condition, clean debris and old gasket material, then fit the replacement head and tighten fasteners to the manufacturer's recommended torque values. If the engine manual calls for threadlocker or a specific head gasket, follow those instructions rather than applying ad-hoc methods.

Tuning and service role: this cylinder head serves as a replaceable component for routine maintenance, bench repairs, and pre-event checks. It supports restoring correct compression sealing and enables consistent warm-up and run-in behavior when used alongside properly maintained carburetor and ignition settings.

Will this head fit every O.S. 46AX variant?

The OS24604000 is intended for the 46AX series shown by the part number; verify fit against your engine serial and official documentation prior to purchase.

What tools do I need to remove and fit the head?

Basic hand tools are normally sufficient. Use the correct size hex driver and a calibrated torque wrench, and follow the torque guidance from the engine manufacturer to avoid damage.

What checks should I perform after installing the new head?

After installation, run the engine in a controlled way and inspect for leaks, unusual noises, and a stable idle. Make tuning adjustments according to the engine manual if required.

Copyright © 2008-2026 rcjaz.ca All rights reserved