MUGEN MTX-5 Rear Lower Suspension Shaft Pair - Arrowmax AM-MTX-T2127  [AM-MTX-T2127]

Rear lower link shaft for MTX-5 upkeep

This Arrowmax AM-MTX-T2127 replacement shaft is supplied as 2 pcs and is intended for use with MUGEN MTX-5 chassis. Machined in spring steel, the shaft functions as a direct replacement for the rear lower link mount, helping preserve the intended suspension geometry and consistent linkage movement during track sessions.

Fitting is straightforward: remove the rear lower link assembly, check existing mounting hardware and link bushings for wear, pass the new shaft through the lower link and secure according to your chassis instructions. The component keeps factory locations intact while allowing straightforward replacement during maintenance or setup changes.

Tuning impact: although a small wear item, the shaft controls lateral and fore-aft positioning of the lower link. Replacing worn shafts in matched pairs helps retain left/right symmetry and predictable suspension response when you change spring rates, damping or link positions to tune roll centre.

Note: this item is offered as an RC accessory for the MUGEN MTX-5 chassis and does not include tools for installation.