Mugen MTX-4 Rear Brace RH Aluminium MTX4-08/TI by 3Racing  [MTX4-08/TI]

Right-hand aluminium rear brace for MTX-4

This right-side aluminium rear brace is made to fit the Mugen MTX-4 rear assembly and carries the 3Racing part code MTX4-08/TI. The piece features a titanium-look finish and serves as a direct replacement or upgrade to influence chassis rigidity and rear-end behaviour in race or club-level setups.

Installation uses the MTX-4's existing rear mounting points and swaps in place of the stock RH brace without chassis modification. The brace stiffens the rear bulkhead connection to help drivers fine-tune transient traction and overall rear response through setup changes rather than altering suspension geometry.

When fitting, inspect the original mounting hardware and reuse screws when they are in good condition. Typical RC hex drivers are suitable for assembly, and you should confirm clearance around the body mounts and shock tower during the first test fit.