Mugen MRX-5 Clutch Pressure Plate 7075 HARD - Arrowmax AM-MRX5-H2702  [AM-MRX5-H2702]

Aftermarket pressure plate for MRX-5 clutches

This Arrowmax AM-MRX5-H2702 pressure plate is made for use with the Mugen MRX-5 clutch assembly and is machined from 7075 aluminum in the HARD specification. The harder surface gives a firmer contact point inside the clutch pack compared with softer plate options.

The plate replaces the original pressure plate in the MRX-5 stack and uses the existing clutch hardware and mounting points. Installation concentrates on correct alignment and maintaining proper clutch stack height when reassembling the unit.

Use this plate to fine tune engagement feel and consistency rather than to alter engine or gear output. After installing, check clutch alignment, clearances and the condition of friction surfaces, then perform cautious low-speed tests to verify behaviour before running at race pace.

Compatibility

• Mugen MRX-5

Ideal for MRX-5 based 1/10 on-road cars where a firmer clutch engagement is required, always verify fit and perform stepwise testing after installation.