MP11 Cap Universal Swing Shaft (2pcs, L=93) - Kyosho IF752  [KY-IF752]

Cap universal swing shaft summary

This Kyosho IF752 Cap Universal Swing Shaft is an RC driveline spare intended for use with MP11-designated setups as shown in the product title. The kit includes 2pcs and the L=93 designation denotes the shaft length referenced by the chassis documentation.

The item functions as a replacement cap for the universal swing shaft within the transmission and driveline area, helping to maintain axle alignment and transfer torque where a compact joint with controlled articulation is required. It is supplied as a direct spare rather than a performance upgrade; check fitment against your vehicle parts list and existing hardware before installing.

Installation notes: remove the related driveline section and compare the existing shaft length and mounting points prior to fitment, confirm that L=93 matches your original part, and reassemble with correct fastener torque. Inspect for wear and secure retention after initial test runs as part of routine setup.

Tuning role: this component helps preserve driveline geometry through suspension travel and under load, so correct length and condition contribute to predictable handling and drivetrain response when adjusting on-track settings.