Mini-Z Overland Nylon Ball End Set MOL1332/BE for Kyosho by GPM  [MOL1332/BE]

Replacement nylon ball ends for Mini-Z Overland linkages

This RC accessory replaces and upgrades ball end terminations on Mini-Z Overland linkages, supplied as a paired set referenced by MOL1332/BE. Molded nylon construction is used for linkage and suspension connections where smoother articulation and reduced binding are preferred.

Fit and role: these ball ends act as the pivot between control arms and turnbuckles or steering linkages, influencing geometry and steering response; install them when original metal or worn ball ends need replacement or when slightly freer movement is required for tuning.

Installation notes: thread the ball end onto the existing ball stud and confirm proper engagement where applicable, avoid over-tightening to prevent stripping, and check nearby clearances after mounting to ensure there is no interference. Inspect periodically for wear if you use the model frequently.

Tuning guidance: fitting nylon ball ends can lower friction at pivot points compared with harder materials, which may smooth small steering twitching without changing base geometry; consider them as a subtle tuning tweak rather than a major setup change.