Mini-Z MR-03 Setting Shim Set 0.2mm (2pcs) - Kyosho MZW131  [KY-MZW131]

Mini-Z 0.2 mm tuning shims

This Kyosho MZW131 shim set is an RC-scale accessory supplied as two 0.2mm shims intended for small adjustments on Mini-Z models. The parts are offered as a compact pair to change clearances where consistent, repeatable spacing is needed.

Compatibility: the product is listed for the Mini-Z series MR-03 chassis. Use these shims when you want incremental spacing changes without altering parts or machining new components.

Typical uses include fine-tuning gear mesh clearance, correcting small misalignments in transmissions, and adjusting contact points in tight assemblies. Because each shim is thin, you can stack them to achieve greater thickness while keeping changes controlled.

Installation guidance: inspect the assembly to confirm a shim is the right solution for clearance adjustment, position the shim between the mating surfaces that need spacing, verify moving parts rotate freely after fitting, and recheck clearances under a light operating load. Avoid adding excessive shim thickness to prevent binding.

Handling note: keep the two pcs together and mark thickness if you store other shim sizes, so future tuning stays consistent with earlier setups.