Mini-Z MB-010 M2 Pillow Ball Link (8pcs) - Kyosho MB026  [KY-MB026]

Mini-Z MB-010 Pillow Ball Details

This Kyosho MB026 pillow ball is an RC-scale replacement part intended for Mini-Z MB-010 series linkage and steering joints, specified with M2 thread sizing and supplied as a pack of 8 pcs to match typical miniature chassis ball link locations.

The component functions as a compact ball-socket interface that secures linkage pins while allowing articulation. On a Mini-Z MB-010 chassis it is used where a small, low-profile ball joint is required to control tie-rods, steering links, or small suspension link points to help maintain repeatable geometry during setup and use.

Service notes emphasise correct fitment to M2 threaded posts and proper seating in the ball cup. Check mating surfaces for wear before fitting, replace matched sets if multiple joints show play, and confirm free movement across the intended motion range after installation.