Mini-Z F1 Alloy Front Knuckle Arm (0deg) MZF1021 by GPM  [MZF1021]

Kyosho Mini-Z F1 Alloy Front Knuckle Arm (0deg)-1pr - GPM MZF1021
Price:
CAD$16.44
Brand:
GPM
Model:
MZF1021
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Front alloy knuckle for Mini-Z F1 chassis

This front knuckle arm is a replacement steering component for Kyosho Mini-Z F1 owners, identified as model MZF1021. It connects the front hubs to the steering linkage and is made for the 0deg orientation shown in the product name.

Manufactured from aluminium alloy, the part offers improved durability and a firmer steering feel compared with the factory plastic version. It is intended for routine maintenance or light tuning where a more consistent front end response is preferred.

Fitting requires standard Mini-Z front hub and steering disassembly; verify pin diameters, spacers and ball bearings for correct fit before installation. As an adjustment to steering geometry, test any setup changes on a short run to confirm handling behaviour.

Will MZF1021 fit older Mini-Z F1 variants?

Check your chassis designation and front knuckle orientation; this item is specified for Mini-Z F1 0deg configurations and may not fit variants with different steering geometry.

Are new screws or bearings required for installation?

Most stock screws and bearings will reuse, but inspect pins and bearing bores for wear and replace any worn hardware to ensure secure fitment.

How does an alloy knuckle change handling?

An alloy knuckle typically provides a firmer steering response and more consistent feedback under load, which can sharpen turn-in for tuned Mini-Z F1 setups.

Copyright © 2008-2026 rcjaz.ca All rights reserved