Mini-Z AWD Delrin Ridge Rims 6pcs 0mm Offset 8.3mm DMZA601FR888 by GPM  [DMZA601FR888]

Delrin ridge rims for Mini-Z AWD

This DMZA601FR888 set contains matched front and rear Delrin ridge-style rims with pre-mounted tires, made for Mini-Z AWD applications. The specification lists a 6pcs fastening pattern, 0mm offset and an 8.3mm rim width, supplied as one pair for hobby use. The dimensions are chosen to integrate with typical Mini-Z AWD wheel assemblies for handling-focused setups.

Fit and compatibility: these parts are intended for Kyosho Mini-Z AWD platforms. Confirm your wheel hex and hub spacing against the stated 0mm offset and 8.3mm width to ensure clearance with MR-03 AWD or similar chassis suspension and body mounts before installing.

Installation and setup notes: the Delrin rims press-fit onto standard Mini-Z AWD wheel hubs with a 6-point mount and the tyres arrive pre-mounted. After fitting, perform a light wheel truing check to detect any excessive runout. Small changes in rim width or offset will change scrub radius and track width at model scale, so validate handling with short test runs prior to further suspension or weight adjustments.

Tuning role: Delrin rims provide low rotating mass and consistent stiffness at this scale, giving predictable cornering response and weight transfer. Match these rims with suitable tyre foam or rubber compounds for the surface you run on to refine grip and steering without altering motor or electronics setup.