Mini-Z AWD Alloy Rear Knuckle Arm Holder 1.0mm 0.4mm Toe MZA031R+0410 by GPM  [MZA031R+0410]

Alloy rear knuckle holder for Mini-Z AWD tuning

This alloy rear knuckle arm holder is an aftermarket replacement part produced by GPM for Kyosho Mini-Z AWD models, supplied as a single pcs unit. The plate is specified at 1.0mm thickness and carries a built-in 0.4mm toe-in offset to allow fine rear suspension geometry adjustments on Mini-Z AWD platforms.

Fit and role: the component acts as the rear hub pivot mount that secures the knuckle arm and sets the rear toe angle on MR-03 AWD style Mini-Z chassis. Use this holder to replace worn plastic carriers or to test small static toe changes that alter rear-end balance and traction.

Installation notes: follow standard Mini-Z disassembly, remove the rear hub assembly, swap the stock carrier for this alloy holder, and reuse original screws and bearings where they match. Verify clearances after fitting and ensure the knuckle rotates freely without binding. No extra hardware is included unless the seller specifies otherwise.