Mini Spyder MT Motor Mount Replacement - Serpent 440128  [SER440128]

Mini Spyder MT motor mount overview

This Serpent 440128 motor mount is an RC-scale replacement part intended specifically for the Mini Spyder MT platform. It serves as the mounting interface between the motor and the chassis, maintaining correct positioning for reliable gear mesh and drivetrain alignment.

Compatibility is limited to the Mini Spyder MT; verify chassis fit before installing. This component provides mechanical placement and alignment only, not electrical or electronic functions, so confirm motor and spur/pinion orientation during reassembly.

Installation overview: remove the motor and existing mount from the chassis, transfer any required spacers or bearings, fit the replacement mount to the same mounting points, then reinstall the motor and check gear mesh and shaft alignment at neutral suspension travel. After initial fitting, perform a short test run and recheck mounting hardware for secure torque and unchanged gear engagement.

The mount is useful when restoring proper motor position after impacts, when replacing a damaged mount, or when performing drivetrain tuning where precise motor alignment affects gear wear and noise levels.