Mini Spyder MT Front/Rear Shock Towers - Serpent 440103  [SER440103]

Replacement shock towers for Mini Spyder MT

The Serpent 440103 shock towers are replacement RC-scale components made for the Mini Spyder MT platform. They act as the shock mounting points and directly influence suspension geometry, impacting ride height, camber behavior and shock leverage. This overview addresses fit, installation guidance and how tower choices affect setup.

Compatibility: intended for the Serpent Mini Spyder Monster truck RTR EP chassis family listed as Mini Spyder MT. Confirm your chassis code and compare mounting hole patterns before ordering to ensure correct fitment.

Installation tips: remove the body and top mounts, support the chassis, then unbolt the old towers following your vehicle layout. Fit the new towers with the original mounting hardware, tighten screws to a firm but not excessive torque to avoid stripping plastic threads, and check shock eyelet alignment before final tightening. Typical hobby hex drivers and correctly sized screws are usually all that are required.

Tuning role: swapping tower pieces or using towers with alternative hole patterns changes shock angle and leverage ratio, which alters damping response and roll behavior. Make small incremental adjustments to tower positions and test on representative terrain to judge handling effects.