Mini Spyder MT Adjustable Steering Trackrods - Serpent 440109  [SER440109]

Direct-fit steering trackrods for Mini Spyder MT

This is an RC-scale steering trackrod set intended as a direct replacement or service part for Mini Spyder MT models. The components connect the servo output to the steering knuckles and are used when repairing damage or making small geometry adjustments to the steering system.

Focus on fitment: compare the rod-end thread size and overall linkage length with your existing assembly before you fit them, confirm correct thread engagement, and verify free movement through the full suspension travel. These trackrods are made for hobby remote-control monster truck use only.

Installation notes: remove the wheel hubs if needed to reach the steering knuckle, secure rod ends using the original-style fasteners, and tighten fasteners to the manufacturer's recommended torque for plastic or metal steering parts. After fitting, centre the servo and check neutral steering before final tightening.

Tuning role: use the adjustable trackrods to change toe and steering response in small increments so your truck stays predictable on the surface you run. Minor length changes can reduce understeer or sharpen turn-in depending on tyre and suspension setup.