Mini 4WD Cylindrical Mass Damper 4.3g M4WD-06/LB by 3Racing  [M4WD-06/LB]

Tamiya Mini 4WD Cylindrical Weight 4.3g(Light Blue) - 3RACING M4WD-06/LB
Price:
CAD$6.18
Brand:
3Racing
Model:
M4WD-06/LB
Condition:
Brand New
Write a review

M4WD-06/LB cylindrical weight for Mini 4WD

This compact cylindrical weight is specified at 4.3 grams in a light-blue finish and is intended for use as a localised mass damper on Mini 4WD cars. The component is a single-piece cylinder meant to add discrete mass where the chassis or body permits mounting, rather than a multi-part damper assembly.

Compatibility depends on available mounting points or mass-damper slots on the model rather than on a single chassis name. The listing clarifies nominal mass and colour; if you run a specific Super-II, MS, MA or other chassis, confirm shaft diameter and length with the vendor before installing. Do not assume a universal fit without checking dimensions.

Colour and weight are given in the title; material and exact external dimensions are not listed in the source name, so request measurements or photos from the seller when precise sizing is required for tuning or matched displays.

Can this cylinder be used in common Mini 4WD damper holders?

Fit is determined by the holder's internal diameter and mounting method. The product title shows weight and colour but not shaft dimensions, so check the vendor specifications or measure the part on arrival.

Is the 4.3g figure a nominal specification?

The listing gives 4.3g as the nominal weight. If gram-accurate balance is critical for your setup, ask the seller for a measurement or weigh the item when you receive it.

Are mounting adapters included with the cylinder?

The product name does not list any hardware. Treat the item as the cylindrical weight only unless the product page explicitly states adapters or additional parts are included.

Will the light-blue finish be consistent between batches?

Colour names indicate intended finish but batch variations can occur. For display-matched builds, request photos or batch details from the supplier.

Where can I get exact dimensions and material info?

The manufacturer or the seller should be asked for shaft diameter, length and material. If the listing omits these, request a dimensional photo or drawing.

Copyright © 2008-2026 rcjaz.ca All rights reserved