MG215T/0.5M 15T Motor Pinion Gear, 0.5mm Module, 2.2mm Bore by GPM  [MG215T/0.5M]

40Cr Steel Motor Gear 15T ( Module:0.5mm, Motor Tooth Diameter:2.2mm) - GPM MG215T/0.5M
Price:
CAD$11.10
Brand:
GPM
Model:
MG215T/0.5M
GTIN:
4894538411508
Condition:
Brand New
Write a review

15T Pinion Overview

This MG215T/0.5M pinion is an RC motor gear engineered for small electric motors that use a 0.5mm module and a 2.2mm motor bore. The 15-tooth profile and round bore accept standard motor shafts of the stated diameter.

Manufactured from 40Cr steel and heat-treated to improve wear resistance versus untreated parts, the gear fastens to the motor shaft with two 3x3 set screws for a straightforward mechanical clamp when torqued correctly.

Fitment and use tips:

  • Confirm your motor uses the 0.5mm module and 2.2mm bore before ordering to ensure compatibility.
  • Clean and deburr the motor shaft before fitting, and tighten both 3x3 set screws evenly to avoid misalignment.
  • Use this pinion as a like-for-like replacement only when the 15T tooth count, 0.5mm module and 2.2mm bore match your existing drivetrain.

Which motors are compatible with this pinion?

Any motor that uses a 0.5mm module pinion interface and a 2.2mm motor bore will accept this 15T gear. Always measure both the module and the bore to confirm fit.

How can I verify my motor's module and bore?

Use digital calipers to check the pinion module against a known 0.5mm part and measure the internal bore diameter across its widest point to confirm the 2.2mm size.

Is this a direct replacement for stock gears?

It is intended as a direct replacement only when tooth count, module and bore match the original. This pinion is designed specifically for RC model transmissions.

Copyright © 2008-2026 rcjaz.ca All rights reserved