Medius X26 Upper Steering Block Top (2) - Serpent 402175  [SER402175]

Upper steering block cap for X26

The Serpent 402175 steering block top is an RC-scale upper steering block supplied as a set of 2 pcs intended for X26 steering assemblies. It acts as the upper contact point for the steering knuckle and linkage, offering a consistent mounting surface when replacing worn parts or swapping components during setup changes.

Compatibility notes reference Medius X26 and the related SER400052 steel EP parts in the source naming, so installers should confirm the part codes on their chassis before fitting. The product name pairs this item with steel EP parts where noted, indicating common use in steering assemblies that include steel components.

Installation notes: remove the wheel hub or knuckle as needed to access the top steering block, transfer any bearings or spacers from the old part when applicable, and secure with the original hardware while watching thread engagement and following standard RC torque practice. Do not overtighten and verify there is no binding through the full steering travel before running.

Tuning role: swapping the steering block tops is an uncomplicated way to restore straight tracking, reduce play in the steering linkage, and keep steering geometry consistent after impact or wear. Use this as a like-for-like replacement or as part of measured setup changes to preserve alignment and steering response.