Master Drift MD3.0 Differential Height Adapter L/R - MD-DHA-3 by Yokomo  [MD-DHA-3]

Precision Aluminum Diff Height Adapter (L and R)

This MD-DHA-3 set is a machined aluminum left and right adapter for the Master Drift MD3.0 platform, intended for 1/10 drift chassis where small differential height shifts tune handling and rear traction.

The adapters suit the MDR-030 family and replace or augment stock diff mounts to alter differential case height. Machined aluminum offers a firmer mounting surface that resists compression compared with softer materials.

Installation is straightforward for experienced tuners: remove the differential from the chassis, fit the left and right adapter pieces to the diff housing or chassis mounting points as required, and secure using the original mounting hardware. Verify chassis geometry after fitting and re-check fastener torque following a short test run.

On-track tuning note: changing diff height alters driveline angle and can subtly influence steering response and rear traction; test one variable at a time and record results for consistent comparisons.

If you plan iterative setup changes, keep a log of diff height positions and lap feedback; the MD-DHA-3 lets you make repeatable adjustments without altering the diff internals.