The MX3057 kit from GPM is a purpose-built aluminium upgrade that replaces the stock rear linkage with an extended swing arm, a lengthened pull rod and a matched chain to increase the rear wheelbase by 30mm on LOSI Promoto-MX machines. The parts are machined aluminium designed to restore correct geometry after extension while keeping a compact, scale appearance.
The upgrade is tuning-oriented rather than decorative: lengthening the swing arm shifts chassis balance and changes rear traction behaviour. The longer pull rod and supplied chain keep steering geometry and final drive alignment correct once the arm is fitted. Installation requires removing the factory arm and reusing bearings and fasteners where applicable; no specialised tools are required beyond standard workshop gear.
Fit this kit to improve high-speed stability or to refine traction on firmer surfaces; always confirm compatibility with your exact LOSI Promoto-MX variant and check chain alignment during break-in runs.
LOS264000+LOS264001+LOS262000
The MX3057 aluminium +30mm swing arm kit gives a direct route to lengthen the wheelbase on specified LOSI Promoto-MX platforms, supplying the longer pull rod and chain required after extension and helping tune rear traction and stability on the motorcycle chassis.
Copyright © 2008-2026 rcjaz.ca All rights reserved