LOSI Promoto-MX Rear Caliper Aluminum Replacement JR-LMX06-BK by Jazrider  [JR-LMX06-BK]

Team Losi Promoto-MX Motorcycle Aluminum Rear Caliper (Black)
Price:
CAD$9.08
Brand:
JAZRIDER
Model:
JR-LMX06-BK
Condition:
Brand New
Available in shop
Write a review

LOSI Promoto-MX Aluminum Rear Caliper Overview

This aluminum rear caliper is an RC-scale replacement made for Promoto-MX Motorcycle models, sold as part number JR-LMX06-BK. It serves as an aftermarket rear braking option for Promoto-MX dirt bike models and is intended for radio-controlled use only.

The choice of aluminum and the caliper geometry aim to deliver a robust, serviceable unit that fits existing rear brake mounts on the Promoto-MX chassis. The caliper secures brake pads and linkage points and simplifies swaps during routine maintenance or setup changes.

Installation notes: remove the rear wheel and original caliper, transfer any reusable pads or hardware if applicable, mount the caliper to the original mount points, then reassemble and test brake engagement at low throttle. Use the correct-sized hex driver for the mounting fasteners and verify pad clearance before running.

Will this caliper fit every Promoto-MX variant?

The caliper is designed for Promoto-MX Motorcycle models but fit can vary between specific variants; check your bike's rear brake mount geometry against the JR-LMX06-BK before purchase.

Are mounting screws or brake pads supplied?

The listing does not guarantee included hardware or pads. Expect to reuse existing mounting screws and pads where possible or source compatible replacements if needed.

Basic installation checklist?

Remove the rear wheel and old caliper, transfer pads when reusable, fit JR-LMX06-BK to the factory mounts with the appropriate hex driver, check pad-to-rotor clearance, then perform slow-range brake tests before full running.

Copyright © 2008-2026 rcjaz.ca All rights reserved