These 7075 aluminum fork tubes are a direct-fit replacement made for LOSI PROMOTO-MX 1/4 dirt bike models. The machined tubes are intended for front fork maintenance, repair, or light suspension tuning to restore correct ride geometry.
The kit fits at the front wheel assembly and is supplied as a matched pair to replace both fork legs. Installation requires disassembly of the fork housings, removal of the original tubes, and careful reassembly using the supplied rubber sealing rings to preserve axle-side sealing. Accurate measurement and use of model-specific parts help keep predictable handling on the RC chassis.
As an aftermarket hop-up, the 7075 aluminum construction gives increased stiffness compared with common stock components, supporting consistent geometry during setup changes and routine service. Verify the compatible model codes shown below before starting the install.
LOS263005
Use this GPM MX142 fork tube set when replacing worn or damaged front fork tubes on the listed LOSI PROMOTO-MX 1/4 models, and inspect seals and alignment during reassembly to maintain handling consistency.
Copyright © 2008-2026 rcjaz.ca All rights reserved