LOSI Mini LMT Hoop Crossbar 7075 Aluminum LMTM009 by GPM  [LMTM009]

7075 Aluminum Hoop Bar for Mini LMT

This hoop crossbar is an RC-scale replacement produced for the LOSI Mini LMT platform, machined from 7075 aluminum to provide a firmer mounting point than the stock plastic part. It trades minimal added mass for improved resistance to deformation during routine running and minor impacts.

The component concentrates on chassis retention and body-mount stability; it helps keep alignment between the front and rear hoop mounts and reduces the flex that can develop where the original plastic tends to creep under load. Installation uses the factory mounting points and standard fasteners for a direct swap.

For setup and upkeep, verify fastener torque and check clearance around suspension posts and body mounts after fitting. The crossbar does not change suspension geometry or driveline behaviour; it simply gives a stiffer structural anchor on the Mini LMT chassis.