LOSI LMT 7075 Alloy Steering Servo Mount Plate LMT024L by GPM  [LMT024L]

7075 alloy servo mount for LOSI LMT

This steering servo mount plate is an aftermarket 1/5 standard 7075 alloy component made for LOSI LMT solid axle platforms. It replaces the stock mounting arrangement to give a firmer anchor for larger or higher-torque servos, reducing movement under load while remaining compatible with LOSI LMT servo footprint and nearby chassis features.

Fitting uses the supplied cap and flat head screws plus the thin stainless shims to set an accurate stack height and alignment. The plate seats on the factory servo area and keeps the original servo footprint while offering stronger anchor points; installers should verify servo spline alignment and horn clearance before the final torque. The included shims permit small positional corrections without any chassis modification.

Setup notes: when installing a larger servo pay attention to mount height, horn throw and link geometry to avoid end-stop binding, and confirm steering centring after fitment. The alloy plate will stiffen the local chassis area, so re-check steering endpoints and dual-rate settings on your transmitter to maintain the steering feel you expect.

Choose this plate when you need a firmer servo mounting point for LOSI LMT solid axle models, and always confirm servo clearance and steering geometry during installation to preserve predictable handling.