LOSI 5IVE-TE 3.0 Rear 5mm Titanium Chassis Skid Plate 5T3/331R by GPM  [5T3/331R]

Rear skid protection for LOSI 5IVE-TE 3.0

This 1/5-scale rear chassis skid plate is machined from titanium and made to fit the LOSI 5IVE-TE 3.0 platform. At 5mm thickness the plate provides low-profile reinforcement to the rear underside of the chassis, helping resist abrasion and impacts encountered on loose or rocky terrain during typical off-road runs.

The part is produced with a wire-cut machining process, so fine machining marks and occasional slight burrs at edges are normal and do not affect structural strength. Minor surface scratches can occur during handling or transit; these remain cosmetic and will not reduce integrity when the plate is installed on the RC chassis.

Mounting hardware is supplied in the package and the accessory is assembled to simplify fitment. For reliable retention apply a medium-strength threadlocker to the fasteners to prevent loosening under vibration, and verify torque on the existing hex screws after initial runs. Installation requires basic disassembly of the rear chassis area and standard hex drivers.

In practical setup terms the skid plate is a sacrificial protection item rather than a tuning component. It does not alter suspension geometry or drivetrain ratios, but it can reduce chassis wear and provide a consistent contact surface when sliding over obstacles, helping to keep handling predictable at speed.

Fit this titanium rear skid when you want a durable, lightweight protection plate for routine off-road use on the LOSI 5IVE-TE 3.0, and follow basic mounting checks to ensure secure installation.