Lepton Lex Tail Pitch Lever Stay - Hirobo HI0304049  [HI0304049]

Replacement tail pitch lever stay for Lepton Lex

This RC-scale tail pitch lever stay is intended for use with the Lepton Lex line where indicated, serving as the mounting and stabilising point for the tail pitch linkage in the helicopter's tail assembly. Its role is to keep the pitch lever aligned and to maintain consistent geometry between the lever and the tail rotor pitch link during setup and flight tuning.

Installation is straightforward for technicians familiar with small-model tail assemblies: remove the tail boom cover, check existing linkage clearance, replace the old stay with the new part while ensuring the lever moves freely through its full range, and verify that there is no binding at mid-stick and end positions. Make incremental adjustments to the pitch link if necessary to restore correct neutral and travel settings.

During tuning, confirm tail pitch responsiveness after installation by conducting low-risk hover tests and observing tail authority and trim stability. If any play or unexpected movement appears at the lever pivot, inspect surrounding fasteners and linkages rather than over-tightening, and address ball bearings or linkage ends as needed.