This servo mount is listed under Hirobo's Lepton parts line and is intended as a direct replacement or service part for Lepton LEX assemblies. It acts as the rigid interface that secures a servo to the airframe and keeps the linkage attachment points aligned for accurate flight control inputs.
Installation is straightforward for experienced hobby technicians: remove the existing bracket, seat the mount so mounting holes align with the chassis and servo tabs, and fasten using the original hardware. Take care to center the servo horn and check linkage geometry to prevent binding, and cycle the control surfaces through full travel before making a test flight.
During setup and maintenance this mount helps maintain consistent servo geometry. A correctly fitted mount reduces play at the linkage interface and supports repeatable endpoint and trim adjustments for rotorcraft tuning.
Replace this part when mounting points show wear or when restoring factory alignment after a repair, and always confirm hole pattern and clearance on your specific Lepton LEX airframe before flying.
Copyright © 2008-2026 rcjaz.ca All rights reserved
