LAZER ZX Series Non-Decoration Lightweight Body for LAZER ZX series - Kyosho LAB07LWB  [KY-LAB07LWB]

Unpainted Lightweight Shell Suited to LAZER ZX Models

This Kyosho LAB07LWB non-decoration body is supplied unpainted and untrimmed as a lightweight replacement shell for LAZER ZX series models. It is intended for hobbyists needing a direct spare or a neutral base for custom trimming and paintwork.

Use and purpose: the component functions as the external shell at RC scale, enabling quick body replacement after damage or providing a simple platform to try aerodynamic adjustments during setup. Because it is non-decorated, there are no factory graphics; trimming, aligning mounting holes, and finishing are expected during installation.

Installation notes: position the shell over existing body mounts and scribe hole locations before cutting. Verify clearance on your LAZER ZX chassis and check space around suspension and servo linkages before securing permanently. Use correct body clips and consider energy-absorbing mounts where extra damping is required.

Tuning considerations: this lightweight shell will produce small changes in aerodynamic balance and mass distribution versus heavier decorated bodies. Treat it as a baseline when assessing handling changes following a body swap, and make minor ride-height or wing-angle adjustments to refine balance.

Provided as a practical spare and modifiable base, the LAB07LWB suits LAZER ZX platforms for reliable replacement and ongoing setup work rather than being a finished cosmetic item out of the box.