LAW88 one-way slipper Adjust Screw & Spring Set for LAW88 - Kyosho LAW88-03  [KY-LAW88-03]

Kyosho LAW88-03 - Adjust Screw & Spring Set (ZX7.5)
Price:
CAD$0.00
Brand:
Kyosho
Model:
KY-LAW88-03
GTIN:
4548565524600
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

LAW88 slipper adjuster and spring kit

This Kyosho replacement set supplies the adjust screw and spring components intended for use with the LAW88 one-way slipper clutch in RC models. As RC-scale parts, these items perform the mechanical role of setting preload and engagement behavior inside the slipper assembly without changing primary drive gearing.

Use the kit to refresh worn adjusters or springs, restore consistent slipper engagement, or as part of stepwise tuning when refining traction transfer. The adjust screw sets preload while the spring provides resistance against slip; small changes to screw position produce noticeable shifts in engagement feel.

Installation notes: remove the slipper housing following your chassis manual, swap the old adjust screw and spring for the new parts, and reassemble. Make incremental adjustments and verify engagement on a bench or at low speed before full use. This product is intended specifically for the LAW88 one-way slipper clutch assembly.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What specific clutch is this designed to replace parts for?

This set is made to replace the adjust screw and spring inside the LAW88 one-way slipper clutch assembly only, matching the original Kyosho design for that unit.

Will I need specialist tools to fit these pieces?

No specialist tools are required; basic hand tools such as the correct hex driver or small screwdriver for the adjust screw head plus a clean work surface are adequate for the swap.

How should I tune engagement after fitting this set?

Adjust in small increments and test after each change, noting positions so you can return to previous settings. Small rotations of the screw create measurable differences in slip engagement.

What ongoing maintenance is recommended?

Inspect the adjust screw and spring for wear or corrosion during routine slipper servicing, clean contact faces, and replace the set if engagement becomes inconsistent.

Copyright © 2008-2026 rcjaz.ca All rights reserved