KYOSHO Optima 2016 Carbon Front Shock Stay - JR-OT10 by Jazrider  [JR-OT10]

Carbon front shock stay for KYOSHO Optima 2016

This carbon front shock stay is an RC-scale replacement part for the KYOSHO Optima 2016 chassis, listed as JR-OT10. It provides a stiff, stable mounting point for the front shocks so builders and racers can fine-tune shock geometry and front-end behavior without implying any real vehicle application.

Built for hobby use, the stay highlights how upper shock position affects suspension behavior: altering mounting locations and stiffness changes shock angle, travel progression, and front roll response. Fit this part when you need a consistent, rigid anchor for setup work, shock testing, or when trying different shock lengths and spring rates on the Optima 2016 platform.

Installation is straightforward for anyone familiar with 1/10-scale touring or buggy maintenance: remove the existing shock stay, verify the chassis mounting points are clean and undamaged, transfer factory or compatible hardware, and mount the new stay aligning the upper shock mounts. Typical workshop tools such as hex drivers are required. Perform routine fastener checks after initial runs.