Kyosho V One RRR Handle Bar V3R-028 by 3Racing  [V3R-028]

Replacement Handle Bar for V One RRR Steering

This handle bar is a direct-fit replacement for the Kyosho V One RRR and V One RRR Evo steering assemblies, designed to restore precise tie-rod geometry and steering feel without altering the chassis layout.

Fitment and purpose: it installs in the same location as the original steering link or handle bar, preserving correct tie-rod alignment and steering response on on-road RC chassis. Treat the item as a maintenance or setup component rather than a standalone performance mod.

Installation notes: remove the stock unit, verify link lengths and pivot alignment, fit the replacement and confirm full free movement through the steering travel. Inspect for binding and re-centre the steering and toe as required after installation. Reuse the existing mounting points and fasteners, and check ball seats and bearings while swapping components.

Setup tips: after fitting, re-check front-end geometry and steering throw. Small adjustments to link lengths or pickup points will change turn-in and mid-corner balance, so run a short trial and fine tune progressively.