Kyosho MP10 Rear Hub Carrier Bush Set - IF613HB-01B  [KY-IF613HB-01B]

Kyosho IF613HB-01B - Rear Hub Carrier Bush Set (MP10)
Price:
CAD$17.73
Brand:
Kyosho
Model:
KY-IF613HB-01B
GTIN:
4548565470112
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $14.90 each $5.68 or 16%
3+ $14.15 each $10.75 or 20%
Write a review

Rear hub carrier bushings for MP10 chassis

This rear hub carrier bush set is an RC-scale replacement part for the Kyosho MP10 chassis, intended to restore correct lateral play and rotational alignment at the rear hub carriers. The set targets the hub-to-carrier interface rather than bearings or drivetrain elements, and is used when worn or loose bushings begin to affect handling and rear suspension geometry.

Installation is straightforward for anyone experienced with rear hub removal: remove the wheel and hub assembly, extract the worn bushings from the hub carrier, press or slide the new bushings into place using light, non-abrasive force, then reassemble with the original hardware. Check axle alignment and free rotation before final tightening to ensure correct operation.

During setup and tuning, these bushings help reduce unwanted slop at the hub carrier pivot to keep toe and camber more consistent under load, which aids handling during extended track sessions. Regular inspection and cleaning of mating surfaces and adjacent ball bearings will prolong component life and preserve predictable rear-end behavior.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What does this part replace on the MP10?

It replaces the pivot bushings at the rear hub carrier on the MP10, addressing axial play and wear where the hub carrier connects to the suspension arm.

Are special tools needed to fit these bushings?

No special tools are required; basic hand tools plus a gentle press or a soft-tap seating method are sufficient. Use care to avoid deforming the new bushings during installation.

Will these fit other Kyosho models?

This set is specified for the MP10 designation. Verify compatibility with your chassis before purchase, as fitment is intended for MP10 hub carriers.

How should I maintain the bushings for consistent handling?

Inspect the bushings during routine maintenance, keep mating surfaces clean, and replace them if excessive play appears. Use light lubricant only where recommended to avoid attracting dirt.

Copyright © 2008-2026 rcjaz.ca All rights reserved