Kyosho Motorcycle Front Chassis Holder - Aluminium KM013 by GPM  [KM013]

This aluminium front chassis holder is an RC-scale accessory made to work with Kyosho motorcycle platforms and provides a rigid mounting point for the front section of the chassis. It helps steady the front-end assembly and gives a repeatable reference when adjusting steering geometry and suspension balance.

Intended for club and track use, the part integrates with existing Kyosho motorcycle frames and hardware patterns without altering drivetrain components. The aluminium construction supplies predictable stiffness and resists deformation under typical RC loads, aiding tuners who need consistent front-end behaviour during setup changes.

Installation is straightforward for experienced hobbyists: remove the factory holder, align the replacement with the chassis mounting points, and fasten using the original screws. Use the holder to assess how front-end adjustments affect steering feel and suspension response rather than as a primary tuning control.