Kyosho Motorcycle C10 Aluminium Steering Arm KM026 by GPM  [KM026]

C10 steering arm details

This aluminium steering arm is an RC-scale replacement supplied as 1pcs for Kyosho Motorcycle C10 platforms. It is intended for hobby use where a metal steering arm is preferred over standard plastic parts to provide firmer steering linkage and steadier geometry under load.

Fit and role: the component replaces the original steering arm on compatible Kyosho Motorcycle C10 assemblies, linking the servo output to the front steering assembly. As an aluminium part it delivers higher stiffness than common molded pieces, helping maintain steering geometry during aggressive cornering and when altering linkage lengths for tuning.

Installation notes: confirm the C10 designation and check servo spline and bolt pattern before fitting, then ensure steering travel is free from interference after mounting. Tighten fasteners to secure the arm without over-torquing and inspect linkage alignment and bearing play to achieve consistent steering response.

Practical tuning guidance: fit this arm when a rigid steering connection is needed to fine tune throw and centring behavior, and make small linkage adjustments rather than changing the arm geometry itself. The aluminium arm works well as a routine replacement or as a stable baseline for repeated setup changes.