Kyosho Motorcycle Aluminium Servo and Steering Arm Upgrade KM023TM26 by GPM  [KM023TM26]

Aluminium servo and steering arm for Kyosho bikes

This 2pcs set replaces the stock servo arm and steering arm on Kyosho motorcycle RC models, offering a matched aluminium alternative to the original plastic pieces. The pair is made for 23T servo splines (C9) and the steering arm location noted as C10 where those designations apply on Kyosho motorcycle assemblies.

Installation notes: check spline alignment before you tighten fasteners, reuse the original mounting hardware where it fits, and avoid over-torquing to prevent damage to aluminium threads. Confirm the servo spline engagement and steering linkage clearance at full travel so nothing binds through the suspension and steering range.

Tuning and maintenance: aluminium arms reduce flex under load and give firmer steering feedback, which helps when you are dialing steering response or correcting centring. Inspect screw threads and bearing contact areas regularly and apply a small amount of thread locker to steel fasteners if you notice screws coming loose during running.