Kyosho Mini-Z MR02-LM 3 degree Aluminium Steering Block KZ-15/3/LB by 3Racing  [KZ-15/3/LB]

Kyosho Mini-Z MR-015 Aluminium Steering Block (3 Degree) For Mini-Z MR02-LM - 3Racing KZ-15/3/LB
Price:
CAD$13.98
Brand:
3Racing
Model:
KZ-15/3/LB
Condition:
Brand New
Write a review

3 degree aluminium steering block for Mini-Z MR02-LM

The KZ-15/3/LB aluminium steering block is supplied for Kyosho Mini-Z MR02-LM use and provides a fixed 3 degree steering geometry as a direct-fit front assembly option for racers wanting a metal upgrade to the front steering mount.

Use and tuning role: fitted at the front hub, the aluminium block helps stabilise the steering pivot and is used to refine front-end behaviour for track or practice sessions. It is typically combined with precise wheel alignment and small steering trim adjustments to sharpen entry and mid-corner response on tight Mini-Z courses.

Installation notes: the component matches MR02-LM front assembly mounting points. Confirm stock screws and linkages fit correctly after the swap, check steering travel and end-point clearance before driving, and re-torque fasteners after the initial runs.

Which Mini-Z models will accept this block?

This block is made for the MR02-LM layout; verify your chassis code and front assembly design before fitting to other Mini-Z variants.

Are additional spacers or hardware required?

It is intended as a direct replacement using existing mount points, but check that your stock screws and linkages seat correctly and replace any worn fasteners as needed.

What handling changes should I expect?

A fixed 3 degree block alters front geometry and roll behaviour, which can tighten entry and change mid-corner steering feel when dialling setups for small-track racing.

Copyright © 2008-2026 rcjaz.ca All rights reserved