Kyosho Mini-Z MR-02 (MM) Graphite H Plate - Soft MZII-001A by 3Racing  [MZII-001A]

Kyosho Mini-Z MR-02 (MM) Graphite H Plate - Soft - 3RACING MZII-001A
Price:
CAD$3.45
Brand:
3Racing
Model:
MZII-001A
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Soft graphite H plate for Mini-Z MR-02 (MM)

This soft graphite H plate is made to fit the Kyosho Mini-Z MR-02 (MM) scale chassis. It replaces the MM-spec H plate and is intended for hobby-level chassis tuning rather than structural repair.

Fitting is straightforward: remove the factory H plate and install this graphite unit using the same mounting points and screws. A small hex driver is normally all that is required; no special adapters are needed. The softer graphite increases compliance at the H plate area versus harder plates, letting you fine tune front to rear balance and mid corner behaviour without changing suspension geometry.

Use this plate as an affordable, reversible tuning option when experimenting with chassis feel on indoor layouts or tight club tracks. This component is intended for RC setup work only and is not for real-vehicle use.

Will this fit other Mini-Z versions?

This H plate is specified for the Kyosho Mini-Z MR-02 (MM) chassis and is intended for MM-spec components only. Check your chassis spec before fitting.

How does the soft graphite change handling?

The softer graphite adds slight flex at the H plate, which can smooth mid-corner transitions and shift front/rear weight feel for finer balance tuning.

Any tips for installation?

Use the chassis original screws and moderate torque to avoid over-tightening. A small hex driver and steady hands are all you need for a clean swap.

Copyright © 2008-2026 rcjaz.ca All rights reserved