KYOSHO Mini-Z F1 Front Toe Link 0 Degree MKF-02/0 by 3Racing  [MKF-02/0]

Mini-Z F1 front toe linkage overview

This scale front toe in/out linkage fits KYOSHO Mini-Z F1 chassis and is supplied as the MKF-02/0 replacement part. It locks the front toe at a fixed 0 degree to give a neutral baseline for steering geometry during track setup or bench tuning.

Compatibility is limited to Mini-Z F1 variants that use the same front linkage mount found on KYOSHO Mini-Z F1 models. The component functions as a direct-fit spare or alternative to the stock linkage when a 0 degree toe reference is required for handling checks or stepwise setup changes.

Installation notes: remove the current front linkage following the chassis manufacturer's instructions, inspect ball studs and steering posts for wear, and secure the new linkage with the original hardware. Use the chassis toe adjusters or different length tie rods to alter toe settings, and maintain left/right symmetry to avoid binding.

Tuning role: installing a 0 degree front linkage provides a neutral starting point for steering balance, allowing other suspension and roll adjustments to be assessed without toe bias. Swap to linkages with toe-in or toe-out to study effects on corner entry and mid-corner behavior.

As a practical RC spare, this linkage is useful for setup resets, race-day spares, and controlled tuning sessions on Mini-Z F1 chassis that use the standard KYOSHO front interface.