This RC-scale replacement rear rim fits Mini-z AWD platforms and is identified as model DMZA601RW/0. The rim is a Delrin rear wide ridge type listed as 6p with a 0mm offset and an 11mm rim width, supplied as 1 pr.
Delrin construction keeps the rim light and resistant to wear while giving predictable grip on foam and carpet surfaces commonly used on indoor club tracks. The ridge profile is shaped to suit narrow-profile Mini-z tyres frequently used on AWD setups.
Fitment and tuning notes: intended for Mini-z AWD use only, confirm the 11mm width and 0mm offset match your chassis geometry and body clearance before installation. Typical setup checks include wheel balance, tyre bead seating, and wheel hex alignment; use the correct hex screws and verify no interference with the motor or suspension after fitting.
Copyright © 2008-2026 rcjaz.ca All rights reserved