Kyosho Mini-Z AWD Rear Toe Linkage 3 Degree - AWD-09/3 by 3Racing  [AWD-09/3]

Rear toe link aimed at Mini-Z AWD setup work

This is an RC-scale rear toe in/out linkage made for the Kyosho Mini-Z AWD chassis to replace the stock rear link and deliver a repeatable 3 degree toe setting. The item comes finished in purple and is intended for drivers doing model-level tuning and handling comparisons on Mini-Z AWD cars.

The linkage fixes the rear toe baseline so you can evaluate changes to rotation and corner entry with consistent geometry. Fit this when you need a defined 3 degree toe for comparing setups or improving mid-corner response during practice sessions.

Installation notes: remove the stock rear toe linkage from the Mini-Z AWD, transfer any required ball cups or spacers from the original component, and secure the replacement with the factory hardware. Check thread engagement and confirm the link articulates freely with no binding before running the car.

Tuning tips: begin from the stock toe, fit the 3 degree linkage and make small adjustments while also checking front toe and roll center. Test on the same surface to judge changes, since small rear toe adjustments influence turn-in and mid-corner rotation more than straight-line stability.