KYOSHO Mini-Z AWD Rear Toe Adjustment Link 1 Degree AWD-09/1 by 3Racing  [AWD-09/1]

Mini-Z AWD rear toe tuning link

This in/out rear toe linkage is a scale replacement designed for KYOSHO Mini-Z AWD layouts and carries the part number AWD-09/1. It allows small 1 degree changes to rear toe so hobbyists can refine the balance between rear traction and turn-in sensitivity on compact circuits.

Fitment and purpose: built for Mini-Z AWD chassis that accept a rear toe link swap, this component focuses on tuning corner entry and mid-corner stability rather than altering overall steering geometry. Even a single degree adjustment can change traction transfer and the rear end's willingness to rotate, so make measured changes and test gradually.

Installation tips: install the linkage in place of the standard rear toe link on compatible Mini-Z AWD setups. Check alignment at ride height and confirm left-right symmetry after fitting. Because each setting shifts toe by about 1 degree, perform short controlled runs and change only one increment at a time to observe results.