Kyosho Mini-Z AWD Rear Alloy Knuckle Arm Holder MZA031R/006G by GPM  [MZA031R/006G]

Rear alloy knuckle arm holder for Mini-Z AWD

This replacement rear knuckle arm holder fits Kyosho Mini-Z AWD layouts and is supplied as a single alloy piece. It is formed as a 0mm offset plate with 0.6mm thickness, intended to mount where the rear knuckle arm locates.

Made for hobbyists who prefer a metal alternative to the stock plastic part, this holder is a direct-fit for Mini-Z AWD rear hubs that use the same mounting footprint. Swapping is straightforward using the existing rear hub hardware and basic disassembly of the rear end; no special adapters are required when the chassis follows the Mini-Z AWD arrangement.

On the track, an alloy rear knuckle arm holder alters local stiffness and wear characteristics at the rear hub, which can influence steering feedback and suspension response. When fitting, confirm alignment and bearing seating, and re-use the original screws and spacers unless a dedicated upgrade kit specifies replacements.