KYOSHO Mini-Z AWD Delrin Ridge Rims 8.5mm 0mm Offset DMZA601F/R/0 by GPM  [DMZA601F/R/0]

Delrin ridge wheels for Mini-Z AWD racing

This pair of Delrin front and rear ridge rims fits KYOSHO Mini-Z AWD platforms as a direct aftermarket wheel option DMZA601F/R/0. The rims are formed in Delrin to deliver a low mass wheel seat that reduces rotational inertia while keeping dimensional stability for tight-circuit setups.

These rims are intended where narrow 8.5mm wheel widths and a 0mm offset are required, common in indoor sprint and short-track layouts. The ridge profile helps tyre seating and keeps small-diameter tyres aligned for a more consistent contact patch and faster tyre changes.

Installation notes: the wheels suit Mini-Z AWD hubs that accept the same wheel hex and bore dimensions, and they are normally pressed on or secured with the standard hex screw and wheel nut used on Mini-Z AWD conversions. Verify hub clearance around steering and suspension linkages before final fitment to prevent interference.

Setup and tuning: switching to Delrin rims of this width and offset changes effective track and rotating mass, which can affect turn-in and mid-corner balance. Use them to tighten transient response and stabilise tyre seating on technical indoor layouts.