Kyosho Mini Inferno ST Rear Suspension Holder (3 Degree) MIF-028/TI by 3Racing  [MIF-028/TI]

Kyosho Mini Inferno ST Rear Suspension Holder (3 Degree) - 3RACING MIF-028/TI
Price:
CAD$7.73
Brand:
3Racing
Model:
MIF-028/TI
Condition:
Brand New
Write a review

Rear holder summary

This replacement rear suspension holder fits the Kyosho Mini Inferno ST and is supplied under 3Racing part code MIF-028/TI. It gives a fixed 3 degree rear angle to adjust the chassis rear geometry and influence rear traction and roll behaviour on tight tracks.

Installation follows standard Mini Inferno ST rear hub steps: remove the factory holder, transfer any pins or bearings, then refit the new holder to the rear bulkhead using the original hardware. No special adapters are required when working with compatible Mini Inferno ST rear assemblies.

Tuning notes: the 3 degree offset alters toe and camber response under lateral load; use this holder to increase rear bite on grippy surfaces and then fine tune shock valving and anti-roll settings in small increments to restore balance.

Is this a direct replacement for the Mini Inferno ST rear holder?

Yes. It is designed to bolt into the stock mounting points and uses the original hardware for a direct fit on Mini Inferno ST rear assemblies.

Will fitting this change require different springs or shocks?

Not always. You should reassess spring rate and damping after installation; small changes to damping or anti-roll bars often restore balance without full shock swaps.

What on-track effect should I expect from the 3 degree offset?

Expect a modest rise in rear traction and a slightly tighter mid-corner feel. It is best used on higher grip surfaces or when the front end feels too lively.

Copyright © 2008-2026 rcjaz.ca All rights reserved