Kyosho Mini Inferno ST Rear Shock Tower, Alloy MIF2030 by GPM  [MIF2030]

Alloy rear shock tower for Mini Inferno ST

This alloy rear damper tower is made for the Kyosho Mini Inferno ST chassis and is supplied as a single-piece set with mounting screws. It replaces the factory rear tower to restore original shock mounting positions or to change the rear geometry on the Mini Inferno ST.

The metal construction gives a firmer mounting point than typical plastic towers, helping the shocks keep alignment under cornering and braking loads during club runs and casual bashing. The design accepts the same rear shock stud pattern used by Mini Inferno ST shocks, so it integrates with common setups for tuning rear compliance.

Fitting is straightforward for anyone used to Mini Inferno ST maintenance: remove the stock tower, move across any reusable hardware, and secure this tower with the supplied screws. After installation, check shock alignment and suspension travel and use routine hobby tools to tighten fasteners to a reliable working torque.