Kyosho Mini Inferno ST Rear Aluminum Shock Tower MIF-ST06/BU by 3Racing  [MIF-ST06/BU]

Aluminum rear tower for Mini Inferno ST

This rear shock tower is a direct replacement part for the Kyosho Mini Inferno ST chassis, listed as model MIF-ST06/BU. Made from aluminum, the tower becomes the mounting point for the rear shocks and links, replacing the common plastic mount with a metal-to-metal interface for a firmer rear mounting area.

Fitment is simple: the tower reuses the Mini Inferno ST shock locations and factory hardware, keeping the original geometry while changing stiffness and flex at the rear mounting points. Replacing the plastic tower with an aluminum unit alters how the rear suspension reacts under load, adjusting roll stiffness and shock leverage without touching the internal spring or damper settings.

Installation notes: the part replaces the factory rear shock tower using the same chassis mounting points, so chassis cutting or drilling is normally unnecessary. After fitting, check shock shaft alignment and link movement to prevent binding, and confirm body clearance and full shock travel before driving. For setup changes, shift shocks among the available mounting holes to tune rear roll and balance; small fore-aft or height adjustments will change chassis behaviour.