This RC alloy servo mount is made for Kyosho Mini Inferno ST and Mini Inferno chassis and is supplied as a single 1pc set, MIF024H. It accepts Hitec servos and includes the screws and shims needed to set servo height and centre the output relative to the steering linkage.
The upgrade replaces the stock plastic bracket with a stiffer aluminium mounting point to help keep the servo positioned consistently during tuning and use. The supplied shims let you fine tune servo height without fabricating custom spacers.
Fitment notes: remove the original plastic mount from the Mini Inferno chassis, fit the alloy replacement in the same location and secure with the supplied screws. Check screw alignment and shim placement before final tightening to avoid binding the servo spline. Confirm the servo spline pattern and external dimensions match the mount before completing installation.
Setup advice: the mount is intended to reduce flex at the mounting point so steering trims and endpoint adjustments behave predictably. This is an RC accessory and not for use on real vehicles.
Copyright © 2008-2026 rcjaz.ca All rights reserved
