This alloy servo mount is an aftermarket upgrade made for the Kyosho Mini Inferno ST and Mini Inferno chassis, built to accept standard Hitec and JR servo footprints. It replaces the factory plastic plate to give a firmer mounting point, and the set includes mounting screws plus shims to fine tune servo height and alignment inside the radio bay.
Fitting is simple: remove the stock mount, place the alloy bracket in the radio bay, seat the servo and use the supplied shims to set correct spline engagement and horn clearance, then fasten with the included screws. The shims let you make small vertical adjustments to avoid gear mesh issues or linkage bind without extra parts.
Because the alloy holds geometry under load better than plastic, the mount can help preserve steering consistency and reduce slop that affects handling on a Mini Inferno setup. This part is intended for RC model radio bay mounting only.
Copyright © 2008-2026 rcjaz.ca All rights reserved
