Kyosho Mini Inferno Front Knuckle Arm MIF021 by GPM  [MIF021]

Stiffer alloy front knuckle for Mini Inferno

This alloy front knuckle arm is an aftermarket replacement manufactured for Kyosho Mini Inferno ST and Mini Inferno chassis. It is supplied as a direct-fit upgrade to the stock steering knuckle, keeping the original mounting points so it fits with Kyosho steering assemblies.

The piece is machined from alloy to cut down flex in the steering linkages and help the wheel alignment stay consistent under load. Fitment targets the front steering knuckle location for 1/10 scale RC buggies that use the Mini Inferno platform, both electric and nitro layouts.

Installation notes: check your existing hardware and ball bearings, move any pins or washers from the original knuckle as needed, and use the correct hex screws to clamp the arm without over-torquing. After fitting, verify steering toe and ackerman before final setup to ensure predictable handling.

Tuning role: fitting an alloy knuckle arm gives a firmer steering pivot that reduces unwanted flex, helping steering inputs remain consistent when you adjust caster, toe, or link geometry during chassis setup.