Kyosho Mini Inferno ESC Heatsink MIF-020/OR/SG SSG Graphite Orange Detail by 3Racing  [MIF-020/OR/SG]

Mini Inferno ESC cooling block

This compact heatsink is made to fit Kyosho Mini Inferno speed control locations and matches the MIF-020/OR/SG configuration. It provides passive dissipation for the ESC surface and surrounding electronics, helping to lower operating temperature during long sessions.

Fitting is straightforward for anyone used to Mini Inferno maintenance: the heatsink uses existing screw points or adjacent bracket holes where available and is profiled to avoid common wiring paths and nearby linkages. Check clearance around the motor and throttle linkages before final tightening to maintain full steering and throttle motion.

For best thermal results use the heatsink alongside good chassis airflow, tidy wiring to prevent heat transfer, and secure but not over-torqued fixings. This part reduces surface heat on the ESC under load as a passive solution and is not a substitute for active cooling in high demand setups.