This aluminium alloy heat sink is an aftermarket cooling accessory for the Kyosho Mini Inferno platform, supplied as a single piece. It is made to sit on or beside a Mini Inferno speed controller to improve heat transfer and reduce steady temperature rise during extended track runs or practice sessions.
Installation is simple for hobbyists familiar with basic maintenance: position the sink against the ESC body or fin stack, fasten using the supplied screw into an ESC mounting point or chassis tie location, and verify it does not contact motor leads or moving components. This item is intended for model use only and not for full-size vehicles.
From a setup view, fitting a shallow alloy sink can stabilise ESC temperature under repeated heavy throttle cycles, helping to maintain consistent timing and braking response in hot conditions. After fitting, monitor ESC temperatures over a few runs and tweak airflow or position if you need better cooling results.
Copyright © 2008-2026 rcjaz.ca All rights reserved
